（1）Optimization of Runner Sizes and Process Conditions Considering Both Part Quality and Manufacturing Cost in Injection Molding. Journal of Polymer Engineering, 2011, 31(6-7): 489–494.
（2）Molecular Dynamics Simulation of Bubble Nucleation in Carbon Dioxide/Hexadecane Solution as an Analog to Foaming of Polyethylene by Super Critical Carbon Dioxide. Journal of Plastic Film and Sheeting, 2011, 27(1-2): 117-126.
（3）A Study of Gate Location Optimization of Plastic Injection Molding Using Sequential Linear Programming. International Journal of Advanced Manufacturing Technology, 2010, 49(1): 97-103.
（4）A Numerical Simulation of Full-Shot Microcellular Injection Molding. Journal of Polymer Engineering, 2009, 29(7): 441-453.
（5）Runner sizing in multiple cavity injection mould by non-dominated sorting genetic algorithm. Engineering with Computers, 2009, 25(3): 237-245.
（6）Runner Sizing and Weld Line Positioning for Plastic Injection Moulding with Multiple Gates. Engineering with Computers, 2006, 21(3): 218 – 224.
（7）An Optimization Scheme Based on Flow Resistance to Locate Optimum Gate of Complex Part. Journal of Reinforced Plastics and Composites, 2005, 24(15): 1559-1566
（8）An Improved Algorithm for the Simulation of Injection Molding Filling Process. Journal of Reinforced Plastics and Composites, 2005, 24(7), 691-698
（9）Algorithms for Two Gate Optimization in Injection Molding. International Polymer Processing, 2005, 20(1), 14-18
（10）Algorithm to Optimize Number of Gates and Locations in an Injection Mould. Plastics, Rubber and Composites: Macromolecular Engineering, 2004, 33(8), 330-334